Technical Data

Evo Series Technical Specifications

PhaseSingleSingleSingle
Nominal thermal kW rating7913
Part NumberK070-S1HK090-S1HK130-S1H
MCS ApprovedBBA 0055/36BBA 0055/37BBA 0055/38
Performance data - rated heating output at B0/W35 BS EN14511
Power consumption1.72.163.2
Co-efficient of Performance*4.424.254.03
Immersion heater outputKensa heat pumps do not feature back-up electric immersion heaters**
Brine (primary) based on 0°C in / -4°C out
Design flow rate kg/min23.327.437.9
Pressure drop kPa at design flow rate71117.1
Max inlet temperature °C15
Min temperature °C (outlet)-5 (at standard settings)
Heating water (secondary) based on 30°C in / 35°C out
Design flow rate l/min21.826.938.3
Pressure drop kPa at design flow rate3.984.9510.1
Max flow temperature °C***62
Electrical values at B0/W35
Rated voltage220 - 240V / 50 - 60 Hz
Power supply rating amps252532
Rated current (max) amps17.421.832.7
Typical running current at B0/W35 amps8.812.716.4
Starting current amps18.228.741.3
Refrigerant circuit
Process mediumR407C
Fill volume kg222.2
Compressor typeScroll
Dimensions
H X W X L (mm)1160 x 555 x 575
Dry weight kg153154
167
Operating pressure
Brine circuit min (primary) bar gSettable at commissioning
Heating water circuit min (secondary) bar gSettable at commissioning
Low pressure reset bar gSettable at commissioning
Connection sizes
Primary IN and OUT (speedfit) mm28
Heating flow and return (speedfit) mm28
Performance (based on Average Climate) at 35°C
ErP ratingA++A++A++
SCOP4.694.474.29
Seasonal space heating energy efficiency180%171%164%
Performance (based on Average Climate) at 55°C
ErP rating (based on Average Climate) @ 55°CA++A++A++
SCOP3.673.393.46
Seasonal space heating energy efficiency139%127%130%
Sound Power Level
Sound Power Level (dB)50.954.653.8

 

* The COP figure quoted is calculated as per EN14511.

** In-built immersion heaters will increase running costs and CO2 emissions as they use direct electricity, because of this Kensa heat pumps do not include them.

*** By increasing the flow temperature from the heat pump the efficiency of the unit will drop and the COP decreases.

**** Kensa Evo heat pumps incorporate smart starts as standard to limit the starting current of the compressors. For full details on how the starting currents are calculated please contact Kensa.

Note: Design flowrates are for a ground temperature of 0 and –3oC and a load temperature of 30oC and 35oC