HDPE Pipe

Straight Pipe For Heat Pumps

Kensa can supply three lengths of straight pipe for use with all Kensa ground source heat pumps if pre-coiled slinkies aren’t appropriate. Find out more about these ground arrays on our slinkies and straight pipe page.

Straight pipe features

  • Dimensions: Supplied in 200m, 250m and 300m lengths.
  • Straight pipes are manufactured using 32mm black High Density Polyethylene (HDP) pipe with a pressure rating of PE100+.
  • All straight pipes are leak tested by Kensa.

Useful technical downloads

Want to learn more about ground arrays?

To find out more about straight pipe and heat sources, visit our straight pipe page.

For orders or advice call: 0345 222 4328
Or email: enquiries@thekensagroup.com

Related Accessories

Clarke SPE1200SS purge pump

Purge Pump For Ground Source Heat Pumps

Kensa recommends the Clarke SPE1200SS (part no. 051012200) to purge ground arrays, in order to remove air in the pipes to avoid the heat pump system freezing. The pump comes ready to take a 1” BSP fitting. As a kit, Kensa Heat Pumps provides 2 x 1” BSP Male Iron to 28mm Speedfit connectors. This…
Kensa Ground Source Heat Pump Pre-Coiled Slinky Pipe

Slinky Pipe For Heat Pumps

Pre-coiled slinkies Kensa Heat Pumps manufactures pre-coiled slinkies on-site for supply with all Kensa ground source heat pumps, enabling ease of installation. Slinky pipe features Three pre-coiled slinky pipe length options: 30m, 40m and 50m (indicated by a coloured cable tie). Each slinky features a straight header pipe (typically 25m long), a pre-coiled section (30m,…